User's Manual
Table Of Contents
- Copyright
- Disclaimer
- Emissions
- _
- Table of Contents
- _
- TS4000 Overview
- _
- Configuration Program
- _
- Serial Port
- _
- Radio Setup
- _
- AirNet Packet Protocol
- Overview
- Configuration Options
- Control and Status Strings
- Master-Slave System Setup
- Polled System with Store and Forward Repeaters
- CSMA System Setup
- _
- GPS Configuration
- _
- Testing
- Remote Diagnostics
- Upgrading Firmware
- _
- Licensing
- _
- Service and Support
- _
- Warranty
- _
- Appendix A - Serial Ports
- _
- Appendix B – ASCII Character Set
- _
- _
- Appendix C – Control and Status Strings
- _
- Appendix D – Internal Jumper Block
- _
TS4000 Radio Modem User’s Manual AirNet Packet Protocol 35
address. The user can use as few as one or as many (up to the list size)
address ranges as desired.
Repeating All Network Broadcast Packets
In network broadcast packets the destination group and individual destination
address are zeros. Therefore, setting these addresses to zero in the list will
cause all network broadcast packets, regardless of their source address, to be
repeated
Repeating All Group Broadcast Packets
In group broadcast packets the destination individual address is zero. Therefore,
setting the individual address to zero in the list, for a particular group address,
will cause all group broadcast packets going to that group to be repeated,
regardless of their source address.