User's Manual
Table Of Contents
- Copyright
- Disclaimer
- Emissions
- _
- Table of Contents
- _
- TS4000 Overview
- _
- Configuration Program
- _
- Serial Port
- _
- Radio Setup
- _
- AirNet Packet Protocol
- Overview
- Configuration Options
- Control and Status Strings
- Master-Slave System Setup
- Polled System with Store and Forward Repeaters
- CSMA System Setup
- _
- GPS Configuration
- _
- Testing
- Remote Diagnostics
- Upgrading Firmware
- _
- Licensing
- _
- Service and Support
- _
- Warranty
- _
- Appendix A - Serial Ports
- _
- Appendix B – ASCII Character Set
- _
- _
- Appendix C – Control and Status Strings
- _
- Appendix D – Internal Jumper Block
- _
TS4000 Radio Modem User’s Manual Radio Setup 30
Selection Description
Transmit Data
Inversion
This controls the transmit data polarity in 3295 mode. This
control corresponds to the transmit polarity jumper on the
interface board.
Receive Data
Inversion
This controls the receive data polarity in 3295 mode. This
control corresponds to the receive polarity jumper on the
interface board.
This should be set to match the type of Trimble data link that the TS4000 must
operate with.
This should be set to match the channel spacing of the Trimble data link that the
TS4000 must operate with.
These controls enable store and forward repeater operation in Trimble
compatible mode.
Data Polarity
Trimble Options - Mode
Trimble Options – Channel
Spacing
Trimble Options – Store
and Forward Repeaters