User's Manual
Table Of Contents
- Copyright
- Disclaimer
- Emissions
- _
- Table of Contents
- _
- TS4000 Overview
- _
- Configuration Program
- _
- Serial Port
- _
- Radio Setup
- _
- AirNet Packet Protocol
- Overview
- Configuration Options
- Control and Status Strings
- Master-Slave System Setup
- Polled System with Store and Forward Repeaters
- CSMA System Setup
- _
- GPS Configuration
- _
- Testing
- Remote Diagnostics
- Upgrading Firmware
- _
- Licensing
- _
- Service and Support
- _
- Warranty
- _
- Appendix A - Serial Ports
- _
- Appendix B – ASCII Character Set
- _
- _
- Appendix C – Control and Status Strings
- _
- Appendix D – Internal Jumper Block
- _
TS4000 Radio Modem User’s Manual Radio Setup 29
Compatibility mode allows the TS4000 to be setup to be compatible with our
previous generation TSI9600 radio modem.
Selection Description
Trimble
Compatible
Mode
This mode allows the TS4000 to communicate with Trimble
TrimMark and TrimTalk GPS data links.
TSI9600
Compatibility
Mode
This mode allows the TS4000 to communicate with
Teledesign TSI9600s.
3295
Compatibility
This configures the TSI9600 compatibility mode to be suitable
for operation with JDT-3295 modems.
The JDT-3295 is a TSI9600 with slightly different firmware.
Typically the 3295 consisted of an enclosed TSI9600 modem
and interface board connected with a cable to a separately
enclosed radio transceiver.
Selection Description
Data Scrambling This control is equivalent to the data scrambling DIP switch
on the TSI9600 modem board. On the TSI9600 this switch is
marked “H-F”.
Transmit
Deviation
This sets the amount of transmit deviation. This should be
set to match the level of the TSI9600.
Normally this should not be changed from the default value.
Compatibility
Enable
Data Protocol