WiFi Power Bank User Manual Model: TS-61
Introduction WiFi Power bank is a multi-function device: WIFI router & power bank. It support 3G/4G internet, WIFI, support 5 users connecting simultaneously. Any terminal device, with WIFI function, can get internet through WiFi Power bank. Function 1: Wireless WiFi Router 1. Press the button located on the side of the device for 3 seconds to turn on the device 2. Wait until the three signal LEDs become solid. 3.
No.
6 Press for 3 seconds Turn on or off the device Press for 15 second Reset the device USB-A cable Charge the WiFi Power Bank 8 Micro-USB cable Charge a USB device via micro USB 9 IOS cable Charge a iPhone or iPad 10 Type-C cable Charge a USB device via Type-C 7 Power button Charging cable 11 Charging pins Charge the WiFi Power Bank with cabinet 12 Type-C port Charge the WiFi Power Bank 13 QR code General Safety Instructions: Make sure the WiFi Power Bank is fully charged prior to
Device Specification: Model TS-61 Chipset MT6761 4XA53 @ 2.0GHz Memory 1G RAM+8G ROM Dimensions 132*68*17mm Shell material Plastic ABS+PC Color Ports 3G Network 4G Network Black 1*USB-C, 1*USB-Mirco,1*Apple USB Port Power Out 1*USB-A Power In WCDMA:B1/B2/B4/B5/B8 FDD:B1/B2/B3/B4/B5/B7/B8/B12/B17/B18/B19/B20/B25/B26/ TDD：B38/B39/B40/B41 2.4GHz 802.11b/g/n WiFi 5GHz 802.11a/n/ac 11n 20M&40M,11a band1\2\4(slave) Battery 5000mAh lithium polymer battery Input 5V2A Output 5V1A Temperature S
CE Warning 1. Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instructions. 2. The product shall only be connected to a USB interface of version USB2.0 or higher. 3. Adapter shall be installed near the equipment and shall be easily accessible. 4. The operating temperature of the device can’t exceed 55℃ and shouldn’t be lower than -10℃. 5. The plug considered as disconnect device of adapter. 6.
FCC Warning 15.19 Labeling requirements. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 15.21 Information to user. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. 15.
