Installation Manual
Table Of Contents
- Table of Contents
- I Related Documents
- 1 About This Guide
- 2 M8-Smart
- 3 Components and Power Supply
- 4 Compliance
- 4.1 Manufacturer Information
- 4.2 Risk identification
- 4.3 Safety Warnings
- 4.4 WEEE Information
- 4.5 REACH
- 4.6 Power Usage and Energy Efficiency
- 4.7 EC Declaration of Conformity (No Radio version)
- 4.8 EC Declaration of Conformity (Radio version)
- 4.9 CE Marking
- 4.10 National Restrictions
- 4.11 FCC Statements
- 4.12 Operating Frequency
- 4.13 Intended use of the equipment
- A Technical Information
- A.1 Troubleshooting
- A.2 Updating the software
- A.3 Connecting to the device
- A.4 Connectors
- A.5 Technical Specifications
- A.5.1 Hardware Architecture
- A.5.2 LAN Interface
- A.5.3 WAN Base-T Interface
- A.5.4 WAN SFP Interface
- A.5.5 Wireless WAN interface
- A.5.6 GPS interface
- A.5.7 Wireless LAN Interface (Radio 1)
- A.5.8 Wireless LAN Interface (Radio 2)
- A.5.9 Configuration Interface
- A.5.10 Power Supply
- A.5.11 Dimensions and weight
- A.5.12 Environmental Specifications
- B CE Radio Information
- C FCC Radio Information
Fig. 31: Aux. Connector
3.8 Installing the SIM card
The M8-Smart is equipped with two Wireless WAN interfaces that may need a SIM card (or two) to operate. Certain
services (CDMA) provided by some carriers in several countries do not require SIM cards.
The M8-Smart is equipped with two SIM trays located on the rear panel of the router, as shown in the following fig-
ure.
Fig. 32: SIM trays
To insert the SIM cards in the SIM trays, first remove the cover following these steps:
(1) Insert a screwdriver in the slot.
Fig. 33: Insert the screwdriver in the slot
(2) Press to open the cover.
3 Components and Power Supply Teldat S.A.
18 M8-Smart