manual

bintec W2004n
04.12.2013
Subject to technical alterations
Page 7 / 9
Teldat GmbH - Suedwestpark 94 - 90449 Nuremberg - Germany
Phone: +49 - 911 9673-0 - Telefax: +49 - 911 688 07 25
E-Mail: [e-mail] - www.teldat.org
Wireless LAN (Radio 2)
Data rates for 802.11n, 20 MHz
channel bandwidth
MSC0-23 allow up to 216,7 Mbps PHY rate at 20 MHz channel bandwidth, 3 streams, Short guard
intervall
Data rates for 802.11n, 40 MHz
channel bandwidth
MSC0-23 allow up to 450 Mbps PHY rate at 40 MHz channel bandwidth, 3 streams, Short guard
intervall
Output power limitation (
without antenna gain)
Adjustable in following steps: 5, 8,11,14,16 dBm and maximum. Maximal power varies depending
on data rate, frequency band and country setting.
Output power @ 5 GHz Max. 23 dBm (200mW EiRP)
Automatic Rate Selection (ARS) Available
Transmission rate Automatic
Number of spatial streams
(802.11n)
1, 2 or 3
Bandwidth (802.11n) 20/40 MHz (bundling of two adjoining 20 MHz channels to one 40 MHz channel)
Short guard interval (802.11n) On/off switchable; increase of throughput by reduction of the guard intervals from 800ns to 400ns
DTIM Period Adjustable
Extended Performance Feature Beamforming, MRC (Maximum Ratio Combining), Block-Acknowlegde
Multi SSID Up to 8 service sets per radio module, with virtual access points and own MAC address per SSID.
Broadcast SSID On/off switchable
Power management for clients Registering of up to 250 clients per radio module simultaneously in access point mode. Default is
32 clients.
Country-specific settings Channel settings according regulatory domain (802.11d) permitted.
RTS/CTS RTS/CTS threshold adjustable
Security
Encryption WEP/WPA WEP64 (40 Bit key), WEP128 (104 Bit key), WPA personal, WPA enterprise, WPA2 personal, WPA2
enterprise
IEEE802.11i authentication and
encryption
802.1x/EAP-MD5, 802.1x/EAP-TLS, 802.1x/EAP-TTLS, 802.1x/EAP-PEAP, key management, PSK/TKIP
encryption, AES encryption, 802.1x/EAP
Access control list (ACL) MAC address filter for WLAN clients (white list) and dynamic and static blacklist. Black list function
requires WLAN Controller
WIDS (Wireless Intrution
Detection System)
Rogue AP detection: detect foreign Aps, which try to spy out data via SSIDs by permanent
background scanning. This functionality requires WLAN Controller.
WIDS (Wireless Intrution
Detection System)
Rogue Client Detection: detection and protection: detect conspicuous clients, which try to intrude
or interfere the wireless network.In threat case blocking by dynamic black list. This functionality
requires WLAN Controller.
WIDS (Wireless Intrution
Detection System)
Neighbor AP Detection: detection of neighbor Aps with possible influence on performance of own
network. By detected intrusion: SNMP trap or email alert. This functionality requires WLAN
Controller.
VLAN Network segments on layer2 possible. Per SSID one VLAN ID available. Static VLAN configuration
according IEEE 802.1q; up to 32 VLANs supported.