User manual

• Start mode
• BOOTmonitor mode
• Normal mode
After some self-tests have been successfully carried out in the start mode, your device
reaches the BOOTmonitor mode. The BOOTmonitor prompt is displayed if you are serially
connected to your device.
Fig. 38: BOOTmonitor
After display of the BOOTmonitor prompt, press the space bar within four seconds to use
the functions of the BOOTmonitor. If you do not make an entry within four seconds, the
device changes back to normal operating mode.
Note
If you change the baudrate (the preset value is 9600 baud), make sure the terminal
program used also uses this baudrate. If this is not the case, you will not be able to es-
tablish a serial connection to the device.
5 Access and configuration Teldat GmbH
78 bintec WLAN and Industrial WLAN