User manual

ation of a bridge link, you need the following data:
Configuration of a bridge link
Access data Example value Your values
Preshared key 
MAC address of remote bridge &&&&'&(
To use the bridge link autoconfiguration function, proceed as described in the WLAN Auto-
matic Configuration of a Bridge Link Workshop; for additional information, also read the
user's guide chapter Wireless LAN under WLAN->Bridge Links->New.
4.3.2 Configuring a PC
In order to reach your device via the network and to be able to carry out configuration, the
PC used for the configuration has to satisfy some prerequisites.
• Make sure that the TCP/IP protocol is installed on the PC.
• Select the suitable IP configuration for your configuration PC.
The PC via which you want to configure the IP address for your device must be in the
same network as your device.
Checking the Windows TCP/IP protocol
Proceed as follows to check whether you have installed the protocol:
(1) Click the Windows Start button and then Settings -> Control Panel -> Network Con-
nections (Windows XP) or Control Panel -> Network and Sharing Center->
Change Adapter Settings (Windows 7).
(2) Click on LAN Connection.
(3) Click on Properties in the status window.
(4) Look for the Internet Protocol (TCP/IP) entry in the list of network components.
Installing the Windows TCP/IP protocol
If you cannot find the Internet Protocol (TCP/IP) entry, install the TCP/IP protocol as fol-
lows:
(1) First click Properties, then Install in the status window of the LAN Connection.
(2) Select the Protocol entry.
(3) Click Add.
(4) Select Internet Protocol (TCP/IP) and click on OK.
4 Basic configuration Teldat GmbH
52 bintec WLAN and Industrial WLAN