User manual

4.2 System requirements
For configuration, your PC must meet the following system requirements:
• Internet Explorer oder Mozilla Firefox
• Installed network card (Ethernet)
• DVD drive
• TCP/IP protocol installed (see Configuring a PC on page 52)
4.3 Preparation
To prepare for configuration, you need to...
• Obtain the data required for the basic configuration.
• Check whether the PC from which you want to perform the configuration meets the ne-
cessary requirements.
• install the Dime Manager software, which provides more tools for working with your
device.
4.3.1 Gathering data
The main data for the basic configuration can be gathered quickly, as no information is re-
quired that needs in-depth network knowledge. If applicable, you can use the example val-
ues.
Before you start the configuration, you should gather the data for the following purposes:
• IP configuration (obligatory if your device is in the ex works state)
Note
bintec W1003n, bintec W2003n, bintec W2003n-ext and bintec W2004n do not sup-
port WDS, Bridge Links or Client Mode.
• Optional: Configuration of a wireless network connection in Access Point mode
• Optional: Configuration of client links in Client Links mode
• Optional: Configuration of bridge links in Bridge mode.
The following table shows examples of possible values for the necessary data. You can
enter your personal data in the "Your values" column, so that you can refer to these values
4 Basic configuration Teldat GmbH
50 bintec WLAN and Industrial WLAN