User manual

3.6.2 Serial interface
Your devices bintec W1002n, bintec WI1040n, bintec WI2040n, bintec WI1065n and
bintec WI2065n have a Serial interface for connection to a console. This supports Baud
rates from 1200 to 115200 Bps.
The interface is designed as a 9-pin SUB-D socket.
Fig. 25: 9-pin Sub-D connector
The pin assignment is as follows:
Pin assignment of the Sub-D port
Pin bintec W1002n function
1 Not used
2 RxD
3 TxD
4 Not used
5 GND
6 DSR
7 RTS
8 CTS
9 Not used
3.6.3 Socket for power supply
The WI devices (bintec WI1040n, bintec WI2040n, bintec WI1065n and bintec WI2065n)
have a 3-pole connection for the power supply. An individual power supply can be connec-
ted with any polarity and to any terminal with 2 pins. If a redundant power supply is selec-
ted (2 mains units) the minus poles must be connected together to terminal 2 and the plus
poles must be connected separately to terminals 1 and 3.
Fig. 26: 3-pole connector for the power supply
Teldat GmbH
3 Installation
bintec WLAN and Industrial WLAN 45