User manual

scribed and enter   as Login at the login prompt in the command
line. Leave the password empty and press the Return key. The device runs through
the boot sequence again.
You can now configure your device again as described from Basic configuration on page 48
.
Note
If you delete the boot configuration using the GUI, all passwords will also be reset and
the current boot configuration deleted. The next time, the device will boot with the
standard ex works settings.
3.5 Cleaning
You can clean your device easily. Use a damp cloth or antistatic cloth. Do not use solvents.
Never use a dry cloth; the electrostatic charge could cause electronic faults. Make sure that
no moisture can enter the device and cause damage.
3.6 Pin Assignments
3.6.1 Ethernet interface
The devices bintec W1002n, bintec WI1040n, bintec WI2040n, bintec WI1065n and
bintec WI2065n have two 10/100 Ethernet interfaces. These are used to connect individual
PCs or other switches.
The Ethernet 10/100 BASE-T interface does not have an Auto-MDI-X function in bintec
W1002n.
The connection is made via an RJ45 socket.
Fig. 23: Ethernet 10/100 BASE-T interface (RJ45 socket)
The pin assignment for the Ethernet 10/100 Base-T interface (RJ45 socket) is as follows:
Teldat GmbH
3 Installation
bintec WLAN and Industrial WLAN 43