User manual

Property Value
(WLAN 1 Ant.1, WLAN 1 Ant.2, WLAN 2 Ant.1, WLAN 2
Ant.2)
Dimensions and weights:
Equipment dimensions without cable
(W x L x H)
257 mm x 285 mm x 60 mm
Weight approx. 1,900 g (with WLAN modules)
LEDs 7 (1x Failure, 1x Status, 2x WLAN, 2x Ethernet, 1x SFP)
Power consumption of the device 5-24 Watt, depending on extensions
Voltage supply Earth conductor/connection to earth 5-20W. All devices
must be earthed.
24 V ± 30% DC 1,1 A with reverse voltage protection, in-
sulated 3-pole
PoE on Ethernet 1 Class 0 (insulated) with max. two
WLAN modules
Protection against theft Theft protection is available as an option
Temperature sensor Temperature monitoring and software-controlled actions
possible
Environmental requirements:
Storage temperature -40 °C to +85 °C
Operating temperature -20 °C to +65 °C
Relative atmospheric humidity 10 % to 100 %
Available interfaces:
Serial interface V.24 Permanently installed, supports Baud rates: 1200, 2400,
4800, 9600, 19200, 38400, 57600, 115200 Baud
Ethernet IEEE 802.3 LAN Permanently installed (twisted pair only), 10/100 mbps,
autosensing, MDI/MDIX 2x 10/100 Base T/TX
Relay An alarm using relay is possible in the event of overtem-
perature or error: potential-free working contact, 42 V AC
1 A / 30 V DC 2 A
Optical interface Module slot for optical interface 100 mbps LWL Single
Mode LC or LWL Multimode LC - 1x 100 Base FX/SX
with SFP module
Available sockets:
Serial interface V.24 9-pin Sub-D connector
Relay switching contact N/O 42 V AC 1 A / 30 V DC 2 A potential-free, software con-
figurable, switchable
Ethernet interface RJ45 socket
Teldat GmbH
3 Installation
bintec WLAN and Industrial WLAN 41