User manual

LED Status Information
off If the device is at the login prompt.
Status (green) off The power supply is not connected. If other
LEDs are on, also Error.
on (static) Error
on (flashing) Ready
WLAN 1/2 (2x green)
WLAN 3 without
function
on (flashing slowly) Free
on (static) At least one client is registered
on (flickering) At least one client is registered and there is
data traffic
on (flashing fast) BLD (Broken Link Detection) active
on (flashing fast) 5 GHz scan active
ETH 1/2 (2x green)
off No cable or no Ethernet link
on Cable plugged in and link
on (flickering) Cable plugged in and link with data traffic
SFP (green) off No data traffic
on Data traffic via the SFP interface.
on (flickering) Cable plugged in and data traffic
3.4.5 Scope of supply
Your device is supplied with the following parts:
Cable sets/mains unit/other Software Documentation
bintec WI1065n
Ethernet cable (RJ-45, STP)
Serial cable (D-SUB9)
3 external standard antennas
Blind stops for SFP
SD slot cover with screw
3-pole screw terminal bar for
the power supply
Companion
DVD
Quick Install Guide (printed)
R&TTE Compliance Informa-
tion (printed)
User's Guide (on DVD)
Safety notices
Teldat GmbH
3 Installation
bintec WLAN and Industrial WLAN 39