User manual

Fig. 21: Antenna configuration for bintec WIx065n devices
3.4.4 LEDs
The LEDs show the radio status, radio activity, Ethernet activity and LED states of your
device. The LED states are indicated by combinations of the LEDs which are explained in
detail in this chapter.
During the heating phase the red Failure LED flashes. The other LEDs then come on dur-
ing booting (if the units are initialised).
Note
Note that the number of active WLAN LEDs depends on the number of existing wire-
less modules.
The LEDs on bintec WI1065n and bintec WI2065n are arranged as follows:
Fig. 22: LEDs of bintec WI1065n and bintec WI2065n
In operation mode, the LEDs display the following status information for your device:
LED status display bintec WI1065n and bintec WI2065n
LED Status Information
Failure (red) on After power-up and during booting or if an
error occurs.
flashes During the heating phase.
3 Installation Teldat GmbH
38 bintec WLAN and Industrial WLAN