User manual

Property Value
Single Mode LC or LWL Multimode LC - 1x 100
Base FX/SX with SFP module
Available sockets:
Serial interface V.24 9-pin Sub-D connector
Relay switching contact N/O 42 V AC 1 A / 30 V DC 2 A potential-free, software
configurable, switchable
Ethernet interface RJ45 socket
Antennas:
Antenna connection RTNC socket
Transmit Power (WLAN) max. 100 mW (20 dBm) EIRP
Standards & Guidelines R&TTE Directive 1999/5/EC
EN 60950-1 (IEC60950); EN 60950-22; EN
301489-1; EN301489-17; EN 55022; EN
300328-1; EN 301893; EN 302502; EN 50371
(Medical equipment EN 60601-1; EN 60601-2; EN
55011)
E1-mark (vehicle licencing)
Buttons Reset and reset to ex work settings possible with
two buttons (1x config reset, 1x HW reset)
To ensure safe operation, the WI series devices have a connection to earth. The minimum
cross-section of the earth lead should be 1.5 mm². The distance between the device and
the connection to earth should be as short as possible.
Fig. 16: Connection to earth bintec WIx040n
Teldat GmbH
3 Installation
bintec WLAN and Industrial WLAN 31