User manual
Field Description
The default value is .
Trials
Enter the number of ping tests to be performed until Destina-
tion IP Address as + applies.
The default value is (.
18.7 Teldat Discovery
18.7.1 Device Discovery
The Teldat Discovery protocol is used to identify and configure Teldat access points that
are in the same wired network as your device. Once an access point has been discovered,
certain basic parameters (node name, IP address, netmask, and device address) can be
configured on the access point (provided you know the administrator password).
Note
Any Teldat access points that exist are determined by means of a multicast. The IP ad-
dress of the access point is therefore irrelevant.
Please note that the discovered Teldat access points are not stored in the flash, which
means discovery must be repeated after you reboot your device.
In the Local Services->Teldat Discovery->Device Discovery menu, a list of all dis-
covered access points in the network is displayed under Results. In the Interface field, se-
lect the interface of your device via which access point discovery is to be carried out. You
use the #"# option to query all interfaces.
The current discovery status is displayed for each individual interface under Discovery
Status. Here, 2 means that no discovery is active. 70, is displayed if a discov-
ery is currently performed.
This discovery function also enables your device to be discovered and configured by other
access points with a discovery function. You configure this in the Options submenu.
18.7.1.1 Discover
Click the Discover button to launch the Teldat access point discovery.
Teldat GmbH
18 Local Services
bintec WLAN and Industrial WLAN 423