User manual

firmware is being loaded.
Note
Note that the number of active WLAN LEDs depends on the number of existing wire-
less modules.
The LEDs on bintec WI1040n and bintec WI2040n are arranged as follows:
Fig. 15: LEDs of bintec WI1040n and bintec WI2040n
In operation mode, the LEDs display the following status information for your device:
LED status display bintec WI1040n and bintec WI2040n
LED Status Information
Failure (red) on After power-up and during booting or
if an error occurs.
flashes During the heating phase.
off If the device is at the login prompt.
Status (green) off The power supply is not connected. If
other LEDs are on, also Error.
on (static) Error
on (flashing) Ready
WLAN 1/2 (2x green)
WLAN 3 without function
on (flashing slowly) Free
on (static) At least one client is registered.
on (flickering) At least one client is registered and
there is data traffic.
Teldat GmbH
3 Installation
bintec WLAN and Industrial WLAN 27