User manual

Warning
Before drilling, make sure that there are no building installations where you are drilling.
If gas, electricity, water or waste water lines are damaged, you may endanger your life
or damage property.
• Screw the mount to the wall with the 2 screws.
• Hang the device in the mount with the screw nut but do not tighten it. Make sure the
device connections are accessible.
• Protect the device against theft with the lock supplied.
Fig. 12: Wall mounting of the bintec WIx040n (standard design, DIN rail or theft protection optional)
3.3.2 Connectors
All the connections are located on the underside of the device.
bintec WI1040n, and bintec WI2040n have two Ethernet ports and a serial interface.
The connections are arranged as follows:
Fig. 13: Underside bintec WI1040n and bintec WI2040n
Underside of bintec WI1040n and bintec WI2040n
1 Power 24V DC Socket for power supply
2 Eth1 (PoE) / Eth2 10/100 Base-T Ethernet interfaces
3 Reset (HW and
Cfg)
Reset button and delete configuration
Teldat GmbH
3 Installation
bintec WLAN and Industrial WLAN 25