User manual

Note
If you delete the boot configuration using the GUI, all passwords will also be reset and
the current boot configuration deleted. The next time, the device will boot with the
standard ex works settings.
3.3 bintec WI1040n and WI2040n
3.3.1 Setting up and connecting
Note
All you need for this are the cables and antennas supplied with the equipment.
Note
For the bintec WIx040n series devices, a screw terminal bar is included as standard
for power supply.
The industrial access point bintec WI1040n is equipped with a single radio module and
three external antennas, bintec WI2040n is equipped with two radio modules and four ex-
ternal antennas.
Devices of the industrial WLAN series with 802.11n support are fitted with a unit that heats
the radio module to operating temperature when the temperature falls below 10 degrees
Celsius. Once this temperature has been reached, the device continues with the start-up
process. During the heating phase the red Failure LED flashes.
3 Installation Teldat GmbH
22 bintec WLAN and Industrial WLAN