User manual

Top
witho
ut
Fig.
ANT1/ANT2 Connections for screwing on the external antennas
ANT1 = TX/RX1 (Connection of first directional antenna)
ANT2 = TX/RX2 (Connection of second option directional an-
tenna)
3.2.3 Antenna connectors
The three antenna for devices bintec W1002n have 2 Transmit and 3 Receive functions in
n operating mode MIMO 2T3R. WLAN 1 Ant. 1 and WLAN 1 Ant. send and receive, Ant. 3
only receives. The connectors on industrial WLAN devices with 802.11n support are the
same as the connectors on other industrial WLAN devices.
3.2.4 LEDs
The LEDs show the radio status, radio activity and Ethernet activity of your device.
All LEDs are on during the start-up process. This means the monitor has been started and
firmware is being loaded.
The LEDs on bintec W1002n are arranged as follows:
Fig. 10: LEDs of bintec W1002n
In operation mode, the LEDs display the following status information for your device:
LED status display bintec W1002n
LED Status Information
Status off The power supply is not connected. If
other LEDs are on, also Error.
on (static) Error
on (flashing) Ready
WLAN 1 on (flashing slowly) Free
on (static) At least one client is registered.
3 Installation Teldat GmbH
18 bintec WLAN and Industrial WLAN