User manual

may be formed.
The standard patch cable (RJ45-RJ45) is symmetrical. It is therefore not possible to
mix up the cable ends.
(3) Power connection
Connect the device to a mains socket.
Use the power cord supplied and insert it in the appropriate socket on your device.
Now plug the power cord into a power socket (100–240 V). The status LEDs signal
that your device is correctly connected to the power supply. Optionally, power can
be supplied through a standard PoE injector (part number 5530000082).
You can set up further connections as required:
• Serial connection: For alternative configuration possibilities, connect the serial interface
of your PC (COM1 or COM2) to the serial interface of the gateway (console). However,
configuration via the serial interface is not provided by default.
Installation
The access points can be fitted to the wall using brackets or can used as a table-top
device.
Use as a table-top device
Attach the four self-adhesive feet on the bottom of the device. Place your device on a solid,
level base.
Wallmounting
To attach the devices bintec W1002n to the wall, use the brackets on the back of the
housing. Optional wall mounting with theft protection (part number 5510000009) is avail-
able.
Warning
Before drilling, make sure that there are no building installations where you are drilling.
If gas, electricity, water or waste water lines are damaged, you may endanger your life
or damage property.
• Screw the mount to the wall with the 2 screws.
• Hang the device in the mount with the screw nut but do not tighten it. Make sure the
device connections are accessible.
• Protect the device against theft with the theft protection.
3 Installation Teldat GmbH
16 bintec WLAN and Industrial WLAN