User manual

3 POWER Socket for power supply
3.1.3 LEDs
The LEDs show the radio status and radio activity of your device.
Note
Note that the number of active WLAN LEDs depends on the number of existing wire-
less modules.
The LEDs on bintec W1003n, bintec W2003n, bintec W2003n-ext and bintec W2004n
are arranged as follows:
Fig. 6: LEDs of bintec W1003n, bintec W2003n, bintec W2003n-ext and bintec W2004n
In operation mode, the LEDs display the following status information for your device:
LED status display
LED Status Information
Status (green) off The power supply is not connected. If
other LEDs are on, also Error.
on (static) Error
on (flashing) Ready
WLAN 1/2 (grün) off Radio or all assigned VSS inactive
on (slowly flashing) VSS is active, no client connected
on (fast flashing) VSS is active, at least one client con-
nected
on (flickering) VSS is active, at least one client con-
nected, active data traffic
You can choose from three different operation modes of the LEDs in the Global Settings
menu as well as with the WLAN Controller.
3 Installation Teldat GmbH
10 bintec WLAN and Industrial WLAN