User manual

(100–240 V). The status LED signal that your device is correctly connected to the
power supply. Optionally, power can be supplied through a standard PoE injector
(part number 5530000082).
Installation
The access points are to be mounted either on the wall or on the ceiling, or use as a table-
top device.
Use as a table-top device
Attach the four self-adhesive feet on the bottom of the device. Place your device on a solid,
level base.
Wall-/ Ceilingmounting
To attach the devices bintec W1003n, bintec W2003n, bintec W2003n-ext or bintec
W2004n to the wall or ceiling, use the appropriate support is included (part number
5500001278).
Warning
Before drilling, make sure that there are no building installations where you are drilling.
If gas, electricity, water or waste water lines are damaged, you may endanger your life
or damage property.
• Screw the mount to the wall or ceiling.
• Hang the device in the mount with the screw nut but do not tighten it. Make sure the
device connections are accessible.
• If desired, protect the device against theft with a Kensington lock.
3 Installation Teldat GmbH
8 bintec WLAN and Industrial WLAN