User manual

Fig. 3: Connection options bintec W1003n
When setting up and connecting, carry out the steps in the following sequence:
(1) Antennas
For bintec W2003n-ext screw the standard antennas supplied on to the connectors
provided for this purpose. If you are using alternative antennas, please note that you
have to connect MIMO antennas to the ports Ant 1 and Ant 2 and a SIMO antenna
to port Ant1.
(2) LAN
For the standard configuration of your device via Ethernet, connect port ETH1 or
ETH2 of your device to your LAN using the Ethernet cable supplied. bintec W1003n
has a single Gigabit Ethernet port, ETH1.
The device automatically detects whether it is connected to a switch or directly to a
PC.
Use just one of the ports ETH1 and ETH2, the second port is used to cascade a
number of devices. If you use both Ethernet connections on the same switch, loops
may be formed.
The standard patch cable (RJ45-RJ45) is symmetrical. It is therefore not possible to
mix up the cable ends.
(3) Power connection
Note
The devices bintec W1003n, bintec W2003n, bintec W2003n-ext and bintec
W2004n are supplied without a mains unit. The power adapter with EU plug (part num-
ber 5500001254) is available as an accessory.
Connect the device to a mains socket. Use the power cord and insert it in the appro-
priate socket on your device. Now plug the power cord into a power socket
Teldat GmbH
3 Installation
bintec WLAN and Industrial WLAN 7