User manual

Fig. 83: Wireless LAN->WLAN->Bridge Links->Automatic Bridge Link Configuration
After successful scanning, a selection of potential bridge partners is displayed in the scan
list. In the Action column, click Select to connect the local bridge with this bridge. If the
partners are connected with one another, the icon appears in the Connected column.
The icon appears in the Connected column if the connection is active.
The Wireless LAN->WLAN->Bridge Links->Automatic Bridge Link Configuration
menu consists of the following fields:
Fields in the Automatic Bridge Link Configuration menu.
Field Description
Bridge Link Descrip-
tion
Displays the name of the bridge link you configured.
Max. Scan Duration Enter the maximum time in seconds for the scan.
Possible values are  to .
The default value is .
Action Start the scan by clicking on Scan.
If the antennas are installed correctly on both sides and LOS is
free, the bridge finds available bridges and displays them in the
following list.
If the partner bridge cannot be found, check the line of sight and
the antenna installation. Then carry out the Scan. The partner
should then be found.
Remote Link Descrip-
tion
Displays the name of the bridge link configured on the remote
bridge.
Remote Device Name Displays the name of the remote bridge.
Signal dBm Displays the signal strength of the detected bridge link.
Teldat GmbH
10 Wireless LAN
bintec WLAN and Industrial WLAN 185