User manual
Field Description
Displays the second channel used.
Bandwidth Only for Wireless Mode = 44, 4,
, 4
Select how many channels are to be used.
Possible values:
• =;D (default value): One channel with 20 MHz bandwidth
is used.
• ' =;D: Two channels each with 20 MHz bandwidth are
used. In the case one channel acts as a control channels and
the other as an expansion channel.
Number of Spatial
Streams
Only for Wireless Mode = 44, 4,
, 4
Select how many traffic flows are to be used in parallel.
Possible values:
• (: Three traffic flows are used.
• : Two traffic flows are used.
• : One traffic flow is used.
Max. Link Distance Only for Operation Mode = *
Enter the maximum link range.
If the + option is enabled, the automatically gener-
ated range is used.
If this option is not enabled, enter the desired maximum value in
the m field.
Option + is active by default.
Transmit Power Select the maximum value for the radiated antenna power. The
actually radiated antenna power may be lower than the maxim-
um value set, depending on the data rate transmitted. The max-
imum value for Transmit Power is country-dependent.
Possible values:
Teldat GmbH
10 Wireless LAN
bintec WLAN and Industrial WLAN 153