User manual
Field Description
Possible values:
• -&
• " ),&
• .# 3",
• *3" F3"
• @"
• "
• ( <"
• (#)
• (#) ),&
The default value is -&.
See RFC 792.
Connection State
Only if Protocol = (2
You can define a filter that takes the status of the TCP connec-
tions into account.
Possible values:
• -& (default value): All TCP packets match the filter.
• #,#: All TCP packets that would not open any new
TCP connection on routing over the gateway match the filter.
Destination IP Ad-
dress/Netmask
Enter the destination IP address and netmask of the data pack-
ets.
Possible values:
• -& (default value)
• ?#: Enter the IP address of the host.
• '17: Enter the network address and the related net-
mask.
Destination Port/Range
Only if Protocol = (2, 0.
Enter a destination port number or a range of destination port
numbers that matches the filter.
14 Networking Teldat GmbH
230 bintec Rxxx2/RTxxx2