User manual

Field Description
ets are always handled with priority.
• 8  9 D33 : QoS is activated on the inter-
face. The available bandwidth is distributed as “fairly” as pos-
sible among the (automatically detected) traffic flows in a
queue. Exception: High-priority packets are always handled
with priority.
• .#, (default value): QoS is deactivated on the inter-
face. The existing configuration is not deleted, but can be ac-
tivated again if required.
Traffic shaping Activate or deactivate data rate limiting in the send direction.
The function is enabled with ,.
The function is disabled by default.
Maximum Upload
Speed
Only for Traffic shaping = enabled.
Enter a maximum data rate for the queue in the send direction
in kbits.
Possible values are  to .
The default value is , i.e. no limits are set, the queue can oc-
cupy the maximum bandwidth.
Protocol Header Size
below Layer 3
Only for Traffic shaping = enabled.
Choose the interface type to include the size of the respective
overheads of a datagram when calculating the bandwidth.
Possible values:
• 0# ! Value in byte.
Possible values are  to .
• 0! ", ? :!!#I (default
value)
Can only be selected for Ethernet interfaces
• 
•   6/-'
•   
Teldat GmbH
14 Networking
bintec Rxxx2/RTxxx2 221