The flexible VPN gateway for all cases bintec R1202 • 5 x Gigabit Ethernet • 19 inch housing with integrated power supply • Web-based configuration / wizards • IPSec - 10 tunnels, opt.
bintec R1202 The flexible VPN gateway for all cases The bintec R1202 VPN gateway with Gigabit Ethernet and an ISDN interface has been designed for SMEs and medium-sized corporate headquarters with higher performance requirements. The bintec R1202 is a powerful and, thanks to its comprehensive equipment, flexible VPN gateway. With its 19-inch metal housing and highly efficient internal switched-mode power supply the gateway guarantees long-term reliability in critical corporate applications.
As a result, there is not only more bandwidth available, but there is the opportunity to spread data traffic across individual WAN connections according to load or data type. Equally, you can use a connection (e.g. SDSL) for the VPN connection of branch offices and external sales staff and use a second WAN port for a low-cost ADSL connection to guarantee the company's other data traffic.
ISDN ISDN protocols Euro-ISDN (Point-to-mulitpoint/Point-to-point) ISDN auto-configuration Automatic recognition and configuration of ISDN protocols ISDN leased lines Supported leased lines: D64S, D64S2, TS02, D64S2Y B channel protocols Excellent interoperability with other manufacturers (Raw HDLC, CISCO HDLC, X.75) X.31 over CAPI Support for various connection paths: X.31/A for ISDN D-channel, X.31/A+B for ISDN B-channel, X.25 within ISDN B-channel (also leased lines) Bit rate adaption V.
VPN IPSec dynamic IP via ISDN Transmission of dynamic IP address in ISDN D or B channel; free-of-charge licence necessary IPSec dynamic DNS Enables the registering of dynamic IP addresses by a dynamic DNS provider for establishing a IPSec connection. IPSec RADIUS Authentication of IPSec connections at a RADIUS server. Additionally the IPSec peers, which were configured on a RADIUS server, can be loaded into the gateway (RADIUS dialout).
Routing BGP4 On request Routing throughput (1518) 199 Mbps with 1518 Byte packets Routing throughput (256) 198 Mbps with 256 Byte packets Protocols / Encapsulations PPP/MLPPP Support of Point to Point Protocol (PPP) for establishing of standard PPP connections, inclusive the Multilink extension MLPPP for the bundeling of several connections PPPoE (Server/Client) Point-to-Point Protocol over Ethernet (Client and Server) for establisching of PPP connections via Ethernet/DSL (RFC 2516) MLPPPoE (Serve
Layer 2 Functionality Bridging Support of layer 2 bridging with the possibility of separation of network segment via the configuration of bridge groups VLAN Support of up to 32 VLAN (Virtual LAN) for segmentation of the network in independent virtual segments (workgroups) Proxy ARP Enables the router to answer ARP requests for hosts, which are accessible via the router. That enables the remote clients to use an IP address from the local net.
Administration / Management Time synchronization The device system time can be obtained via ISDN and from a SNTP server (up to 3 time server configurable). The obtained time can also be transmitted per SNTP to SNTP clients. Automatic Time Settings Time zone profiles are configurable. That enables an automatic change from summer to winter time. Supported management DIME Manager, XAdmin systems Configurable scheduler Configuring of time and event controlled tasks, e.g.
Hardware 19 inch Mountable in 19 inch rack, incl. 19 inch rack mount kit Realtime clock System time persists even at power failure for some hours. Environment Temperature range: Operational 0°C to 40°C; storage -10°C to 70°C; Max. rel. humidity 10 - 95% (non condensing) Power supply Integrated wide range power supply 110-240V, with energy efficient swiching controller Power consumption Max. 15 Watt, typ.
Access Points and Bridges WLAN-Contr.-Bundle 10xW1003n WLAN Controller Bundle contains 10 Access Points bintec W1003n (5510000321) , (5510000351) 1 bintec R1202 (5510000210) and 2 WLAN Controller license (5500000943) WLAN-Contr.
