Operation & Maintenance Manual

TELCOSAT RPT 700
III
SAFETY SUMMARY
High voltage is used in the operation of this equipment.
Death on contact may result if personnel fail to observe the following safety precautions:
 Only qualified trained personnel can install this equipment. Electrical connection and installation
must meet your local Electrical Safety Installation codes.
 Prior to any maintenance or inspection of this device disconnect the power supply.
 Do not remove covers or access plates on the equipment unless you are a trained technician and
authorized to carry adjustment and maintenance for this apparatus.
 When installing antennas always be aware of high voltage overhead power lines. Contact with
power lines will result in severe injury and or death.
 To prevent electrical shock or damage to the equipment, do not operate the repeater until you
thoroughly understand the operation and function of all controls, indicators, and connectors.
 The RPT700 Repeater weighs approximately 65 lbs / 28.5 Kilograms. The repeater must be
attached to the appropriate supporting device using the welded supporting lugs on the enclosure.
The nuts and bolts must be a minimum Grade 5, ¼” (6mm) diameter and corrosion resistant.
FIRST AID
In case of electrical shock:
THIS PERSON COULD STILL BE IN CONTACT WITH ELECTRICAL POWER. DO NOT
TOUCH THIS PERSON BEFORE YOU INSULATE YOUR SELF FROM THE ELECTRICAL
SOURCE.
 Turn off the electrical power.
 If you cannot turn off the electrical power, pull, push, or lift the person to safety using a dry
wooden pole, a dry rope, or some other insulating material. Do not use any metallic objects to
move this person.
 After the injured person is no longer in contact with the electrical source, obtain/perform
immediate medical attention.