Operation & Maintenance Manual

TELCOSAT RPT 700
Page | 6
Document use is restricted to that described on the cover
3. CHAPTER 3
3.1 INSTALLATION
Any modifications to this device will void FCC and IC approvals.
DETAILED SET UP INSTRUCTIONS FOR YOUR RPT700 CELLULAR
REPEATER.
READ THESE INSTRUCTIONS PRIOR TO
INSTALLATION
3.2 WARNINGS
WARNING
DO NOT POWER UP THE REPEATER WITH OUT THE ANTENNAS
CONNECTED
WARNING
THIS IS NOT A CONSUMER PRODUCT. THIS IS A COMMERCIAL PRODUCT THAT
MUST BE INSTALLED AND OPERATED BY TRAINED AND QUALIFIED PERSONNEL.
OPERATION OF THIS PRODUCT REQUIRES NOTIFICATION AND APPROVAL FROM
YOUR CELLULAR SERVICE PROVIDER.
BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have
your provider’s consent. If you are unsure, contact your provider. You MUST operate this device
with approved antennas and cables as specified by the manufacturer. Antennas MUST be
installed at least 22 cm (8.7 inches) from (i.e., MUST NOT be installed within 22 cm of) any
person. You MUST cease operating this device immediately if requested by the FCC (or ISED in
Canada) or any licensed wireless service provider
Cellular Repeaters should be installed by fully trained technicians. Improper installation and
excessive RF power levels can cause interference with the operation of cellular towers.
Antennas must be mounted in a secure safe manner and according to safe working practices.
Lightning protection is recommend and should be installed on every cellular repeater unit.
Antennas must not be installed near overhead electrical power lines as this can cause serious
injury and or death.