User's Manual

Appendix C: Performance Verification

AWG2021 User Manual
b. Select the AWG2021 waveform file:
 Push MODEAutostepSelect Autostep File to choose a
sequence file for CH1.
 Turn the general purpose knob to select the GAIN_OFF.AST file.
 Push ENTER.
3. Check gain accuracy:
 Check that the displayed step is Step 1 on the MODE menu. If it is not,
select the side menu STOP button to return to Step 1.
 Note the DMM reading as “A” for this value.
 Push the AWG2021 MANUAL TRIGGER button, and check that the
displayed step is Step 2.
 Note the DMM reading as “B” for this value.
 Do the following calculation.
A – B
 Check that the calculated value is in the range from 0.4925 V to
0.5075 V.
 Push the AWG2021 MANUAL TRIGGER button, and check that the
displayed step is Step 3.
 Note the DMM reading as “C” for this value.
 Push the AWG2021 MANUAL TRIGGER button, and check that the
displayed step is Step 4.
 Record the DMM reading as “D” for this value.
 Do the following calculation.
C – D
 Check that the calculated value is in the range from 4.925 V to 5.075 V.
4. End procedure: Retain the test hookup and control settings.