User's Manual

EDIT Menu
AWG2021 User Manual
3 Ć101
(3) Button Operations   ! !       

  CURSOR       
 !   
  CURSOR       
   
Settings for the Waveform to be Edited. Before waveform data is created, you
must use the Setting item in the side menu to set the environment for editing.
The method used to set values is the same as for the graphic display. See
“Setting for the Waveform to be Edited” for a description of the graphic display.
Creating Standard Waveform Data. Use this item to create waveform data in the
area between the designated vertical bar cursors.
The following diagram shows the menu configuration for the Standard
Waveform item.



"

"
  
 
 !
# 

"

Pattern Types. Use this item to select the waveform to be created. You can choose
from the following three pattern options:
 Count Up. Data is created sequentially, increasing from the initial value
designated with Min to the maximum value designated with Max. When the
maximum value is exceeded, the waveform will return to the initial value
and begin counting up again. In the example shown in Figure 3 -78, the
waveform point size is 4096, Step has been set to 1, and the Min and Max
values have been set to 0 and 4095, respectively.