User's Manual

Syntax and Commands
PS2520G and PS2521G Programmer Manual
17
Table 4: Miscellaneous Commands (Cont.)
Command Description

Resets the protection levels and states,
resets the current and voltage levels to zero,
sets the output off, and sets memory point to
00.

Initiates internal self-test and reports results.

Wait to continue. This command forces
sequential operation of commands. This
command is required by IEEE 488.1-1987.
The power supply, however, forces sequen-
tial operation of commands by design.

Returns the SCPI version level.

Sets Auto Sequence on or off.
1

Returns Auto Sequence mode.
1
1
Not a SCPI standardized command.