User's Manual
Syntax and Commands
8
PS2520G and PS2521G Programmer Manual
Table 1: Parameter Types for Syntax Descriptions
Parameter Type
Description Example
Boolean Boolean numbers or values ON or 1
OFF or 0
NR1 Integers 0, 1, 15
NR2 Decimal numbers 1.2, 3.141516, 6.5
NR3 Floating point numbers 3.1E–1, 2.01E+1
NRf NR1, NR2, or NR3 1, 1.2, 3.1E–1
string Alphanumeric characters (must be within
quotation marks)
“No error”
MAXimum|MINimum Special mnemonics for setting the parame-
ter to the largest or smallest value the
instrument allows.
MAX, MIN
For the actual value of the parameter type <Boolean>, you may enter
or or you may enter or .
For the command in Figure 5, entering or turns the overcur-
rent protection (OCP) off and entering or turns the OCP on.
The following example includes both the header and a value for the
parameter type:
Parameter values that appear in this manual are often separated by a
vertical line. This vertical line means the same thing as the word
“or.” For example, values for the parameter <Boolean> are
This is the same thing as saying “0 or 1 or OFF or ON.” Any single
value is a valid parameter.
NOTE. Do not include the , , symbols when entering the
actual value for a parameter.