User manual

TekSmartLab™ TBX3000A, TSL3000B User Manual
Configuring Courses
Double click a course to enter the course configuration screen as shown below:
Figure 71: Course configuration screen
5. Click image to change the image of this course. Enter information about this course
in the Course Name and Overview boxes.
6. Set the sequence order of this course by entering a number in the Sequence No.
box.
7. Select the box beside the name of the instruments to use for this course.
8. Click for more detailed configurations.
NOTE:
After you input any information, you should press Enter on your keyboard to finish
9. If you select Reset, when you click Apply to distribute the configurations to the
instruments, the instruments will be reset to the previously saved configurations. If
you only want to reset the instruments, make sure you leave all the parameters un-
configured.
TekSmartLab User Manual 57