User manual

Installation
4. Plug the USB mass storage device into the
adapter.
5. Power on the adapter.
6. Note the color of the A dapter Status LED.
Solid yellow indicates that the firmware
upgrade is in progress. Wait until the
LED changes color.
Blinking green indicates that the
firmware was successfully updated.
Go to step 7.
Blinking red indicates that the firmware
update failed. Go to step 9.
7. If the LED is blinking g reen, p ower off the
adapter, and reconnect the USB and GPIB
cables. (See page 8, Connecting Cables.)
8. Power on the adapter, and verify that the
Adapter Status LED is solid green. This
completes the firmware update procedure.
TEK-USB-488 GPIB to USB Adapter User Manu al 13