User Manual

Command Descriptions
CURSOR:VBARS:
POSITION1?
might return 1.00 E-6, indicating the first vertical
bar cursor is at 1 μs.
CURSor:VBArs:SLOPE? (Query Only)
Returns the change in amplitude divided by the change in time, as measured
between the two cursors. The units are derivable from the CURSor:HBArs:UNIts
and CURSor:VBArs:UNIts queries.
Conditions
This command applies to the TPS2000 Series with TPS2PWR1 Power Analysis
Module only.
Group
Cursor
Syntax
CURSor:VBArs:SLOPE?
Examples
CURSOR:VBARS:SLOPE? might return 1.22E3, indicating the slope measured
between Vertical Cursor 1 and Vertical Cursor 2.
CURSor:VBArs:UNIts
Sets or queries the units for the vertical bar cursors.
NOTE. When Trigger View is active, CURSor:VBArs:UNIts? generates event
221(Settings conflict).
Group
Cursor
Syntax
CURSor:VBArs:UNIts { SECOnds | HERtz }
CURSor:VBArs:UNIts?
Arguments
SECOnds specifies units of time.
HERtz specifies units of frequency (reciprocal of time).
Examples
CURSOR:VBARS:UNITS SECONDS sets the units for the vertical bar cursors to
seconds.
CURSOR:VBARS:UNITS?returnsHERTZ when the vertical bar cursor units are
Hertz.
TDS200, TDS1000/2000, TDS1000B/2000B, TDS2000C, TPS2000 Programmer 2-57