User Manual

Command Descriptions
Group
Cursor
Syntax
CURSor:VBArs:DELTa?
Returns
<NR3>
Examples
CURSOR:VBARS:DELTA? might return 8.92E-1, indicating that the time
difference between the vertical bar cursors is 0.892 seconds.
CURSor:VBArs:HDELTa? (Query Only)
Returns the time or frequency difference between the two vertical bar cursors. The
units (seconds or Hertz) are specified by the CURSor:VBArs:UNIts command. If
the cursor source is an FFT math waveform, CURSor:VBArs:DELTa is always in
Hertz, regardless of the value set by CURSor:VBArs:UNIts .
The command is identical to the CURSor:VBArs:DELTa query. It is included for
compatibility with the TDS3000 Series.
NOTE. If Trigger View is active, this query returns 9.9E37 and generates event
221 (Settings conflict).
Conditions
This command applies to the TDS1000B, TDS2000B, TDS2000C, and TPS2000
Series only.
Group
Cursor
Syntax
CURSor:VBArs:HDELTa?
Returns
<NR3>
Examples
CURSOR:VBARS:HDELTA? might return 8.92E-1 , indicating that the time
difference between the vertical bar cursors is 0.892 seconds.
CURSor:VBArs:HPOS<x>? (Query Only)
Returns the waveform amplitude at the specified cursor position. The units are
specified by the CURSor:HBArs:UNIts query. <x> specifies the cursor. Valid
values are 1 and 2.
TDS200, TDS1000/2000, TDS1000B/2000B, TDS2000C, TPS2000 Programmer 2-55