User Manual

Preface

This programmer manual provides information on how to remotely operate your

oscilloscope. You can use c ommunication ports and protocols, such as for the

RS-232, the G

eneral Purpose Interface Bus (GPIB), or Universal Serial Bus

(USB) standards, to remotely control and operate your oscilloscope.

This document supports the following products:

TPS2000 Series instruments, any version.

TDS2000C Series instruments, any v

ersion.

TDS1000B and TDS2000B Series instruments, any version.

TDS2CMorTDS2CMA,anyversion,whenusedinTDS1000orTDS2000

Series instruments, a ny version.

TDS2MEM any version, when used in most TDS1000 or TDS2000

Series

instruments (except TDS1001 and TDS2004 models), any version.

TDS2CM, TDS2CMA, or TDS2MM a ny version, when used in a

TDS224 instrument, any version.

TDS2CM or TDS2CMA version CMV:v1.04 and above, or TDS2MM any

version, when used in TDS210 and TDS220 instruments with FV:v1.09 and

above.