User Manual

Command Groups
min or max of a mi
n/max pair. Before you can transfer waveform data, you must
specify the data format and waveform locations.
Refer to the te
xt following this table for more information about waveform
commands.
Table 2-28: Waveform commands
Command Description
CURVe Transfer waveform data to or from the
oscillosc
ope
DATa
Set or que
ry the waveform data format and
location
DATa:DESTination Set or query the destination for waveforms
sent to the oscilloscope
DATa:ENCdg Set or query the waveform data encoding
method
DATa:S
OUrce
Set or q
uery the source of CURVe? data
DATa:S
TARt
Set or q
uery the starting point in waveform
transfer
DATa:STOP Set or query the ending point in waveform
transfer
DATa:TARget
Same as DATa:DESTination
DATa :W IDth
Set or query the byte width of waveform
poi
nts
WA V
Frm?
Ret
urn waveform preamble and curve data
WF
MPre?
Re
turn waveform preamble
WF
MPre:<wfm>?
Re
turn waveform formatting data
WFMPre:BIT_N r
S
et or query the preamble bit width of
waveform points
W
FMPre:BN_Fmt
Set or query the preamble binary encoding
type
WFMPre:BYT_Nr
Set or query the preamble byte width of
waveform points
WFMPre:BYT_Or Set or query the preamble byte o rder of
waveform points
WFMPre:ENCdg Set or query the preamble encoding method
WFMPre:NR_Pt? Query the number of points in the curve
transfer
WFMPre:<wfm>:NR_Pt? Return the number of points in the transmitted
waveform record
WFMPre:PT_Fmt
Set or query the format of curve points
WFMPre:PT_Off Query the trigger offset
WFMPre:WFId? Query the waveform identifier
TDS200, TDS1000/2000, TDS1000B/2000B, TDS2000C, TPS2000 Programmer 2-27