User Manual

Command Groups
Table 2-22: Power Measurement commands (TPS2000 with TPS2PWR1 only) (cont.)
Command Description
SWLoss:VALue:TURNON? Return the power loss of the device under
test when the device is transitioning between
its off and on state display
SWLoss:VSAT Set or query the saturation voltage for the
device under test
WAVEFORMANALYSIS:SOUrce Set or query the source for Waveform
Analysis commands
RS-232 Commands(TDS200, TDS1000, TDS2000, and TPS2000 Only)
RS-232 commands allow you to set or query the parameters that control the
RS-232 port.
Table 2-23: RS-232 commands
Command Description
RS232? Query RS232 parameters
RS232:BAUd Set or query the baud rate
RS232:HARDFlagging Set or query the hard agging
RS232:PARity Set or query the parity type
RS232:SOFTFlagging Set or query the soft agging
RS232:TRANsmit:TERMinator Set or query the end-of-line terminator
Only certain oscilloscope models are compatible with RS-232. (See Table 2-1
on page 2-1.)
Save and Recall Com mands
Save and Recall commands allow you to store and retrieve internal waveforms
and settings. When you "save a setting," you save most of the settings of the
oscilloscope. When you then "recall a setting," the oscilloscope restores itself to
the state it was in when you saved that setting.
To display a saved waveform, use the SELect:<wfm> command.
Table 2-24: Save and Recall commands
Command Description
*RCL
Recall setting
RECAll:SETUp
Recall saved oscilloscope setting
RECAll:WAVEForm Recall saved waveform
TDS200, TDS1000/2000, TDS1000B/2000B, TDS2000C, TPS2000 Programmer 2-23