User Manual

Command Groups
Table 2-18: Mea
surement commands
Command Description
MEASUrement?
Return all mea
surement parameters
MEASUrement:IMMed?
Return immed
iate measurement parameters
MEASUrement:IMMed:S O U rce[1] Set or query the channel for immediate
measurement
MEASUrement:IMMed:S O U RCE 2 Set or query the channel for two-source
immediate
measurements (TPS2000 with
Power Analysis Module only)
MEASUrement:IMMed:T YPe Set or query the immediate measurement to
be taken
MEASUrement:IMMed:U N Its?
Return the immediate measurement units
MEASUrement:IMMed:VALue?
Return the immediate measurement result
MEASUrement:MEAS<x>?
Return parameters on the periodic
measurement
MEASUrement:MEAS<x>:SOUrce Set or query the channel to take the periodic
measur
ement from
MEASU
rement:MEAS<x>:TYPe
Set or
query the type of periodic measurement
to be taken
MEASUrement:MEAS<x>:UNIts? Return the units for periodic measurement
MEASUrement:MEAS<x>:VALue?
Retu
rn periodic measurement results
Mis
cellaneous Commands
Miscellaneous commands are a group of commands that do not fit into any other
category.
Several commands and queries are common to all 488.2-1987 devices on the
GPIB or USB bus, and the device on the RS-232 interface. These commands and
q
ueries are defined by IEEE Std. 488.2-1987 and Tektronix Standard Codes and
Formats 1989 and begin with an asterisk (*) character.
Table 2-19: Miscellaneous commands
Command Description
AUTORange
Return all autorange parameters
AUTORange:SETTings Set or query the which parameters autorange
can adjust
AUTORange:STATE Set or query the autorange to on or off
AUTOSet
Automatic oscilloscope setup
AUTOSet:ENABLE
Allows educators to disable or enable the
Autorange and Autoset functions.
1
AUTOSet:SIGNAL? Return the type of signal found by autoset
2-18 TDS200, TDS1000/2000, TDS1000B/2000B, TDS2000C, TPS2000 Programmer