User Manual

Command Groups
Table 2-9: Calibration and Diagnostic commands (cont.)
Command Description
DIAg:RESUlt:FLAg?
Return diagnostic tests status
DIAg:RESUlt:LOG?
Return diagnostic test sequence results
ERRLOG:FIR ST? Returns first entry from error log
ERRLOG:NEXT? Returns next entry from error log
Cursor Commands
Cursor commands provide control over the oscilloscope cursor display and
readout.
Table 2-10: Cursor commands
Header Description
CURSor?
Return cursor settings
Command Set or query the cursors on or off; select
cursor type
CURSor:HBArs?
Return horizontal bar settings
CURSor:HBArs:DELTa?
Return vertical distance between horizontal
bar cursors
CURSor:HBArs:POSITION<x> Set or query the position of a horizontal bar
cursor
CURSor:HBArs:UNIts? Query v ertical scale units
CURSor:SELect:SOUrce Select waveform
CURSor:VBArs?
Return vertical bar settings
CURSor:VBArs:DELTa?
Return horizontal distance between cursors
CURSor:VBArs:HDELTa?
Return horizontal distance between cursors.
Same as CURSor:VBArs:DELTa
CURSor:VBArs:HPOS<x>? Return the amplitude of the waveform at the
cursor position
CURSor:VBA rs:POSITION<x> Set or query the position of a vertical bar
cursor
CURSor:VBArs:SLOPE? Return the value of the on-screen dV/dt or
dI/dt m easurement
CURSor:VBArs:UNIts Set or query the vertical cursors to time or
frequency
CURSor:VBArs:VDELTa?
Return the vertical distance between cursors
2-12 TDS200, TDS1000/2000, TDS1000B/2000B, TDS2000C, TPS2000 Programmer