User Manual

Command Descriptions

NOTE. The "CH3 a

nd CH4" options are only valid for instruments with four

channels.

MATH speciﬁes the math waveform as the analysis source.

Examples

WAVEFORMANALYSIS:SOURCE CH2 speciﬁes Channel 2 as the waveform analysis

source.

WAVFrm? (Query Only)

ReturnsWFMPre? andCURVe? dataforthewaveformspeciﬁed by the

DATa :SOUrce command. This command is equivalent to sending WFMPre;

CURVe. If the waveform speciﬁed by the DATa:SOUrce command is not

displayed, the oscilloscope returns only the waveform transmission parameters

(BYT_Nr, BIT_Nr, ENCdg, BN_Fmt, BYT_Or).

Group

Waveform

Syntax

WAVFrm?

Related Commands

CURVe, D ATa:SOUrc e, WFMPre?

Returns

See WFMPre? and CURVe? commands.

WFMPre? (Query Only)

Returns waveform transmission and formatting settings for the waveform

speciﬁed by the DATa:SOUrce command.

If the waveform speciﬁed by the D ATa:SOUrce command is not displayed, the

oscilloscope returns only the waveform transmission parameters (BYT_Nr,

BIT_Nr, ENCdg, BN_Fmt, BYT_Or).

Group

Waveform

Syntax

WFMPre?

TDS200, TDS1000/2000, TDS1000B/2000B, TDS2000C, TPS2000 Programmer 2-181