User Manual

Command Descriptions
SWLoss:VSAT
Sets or queries the saturation voltage for the device under test.
Conditions
This command applies to the TPS2000 Series with TPS2PWR1 Power Analysis
Module only.
Group
Power Measurement
Syntax
SWLoss:VSAT <NR3>
SWLoss:VSAT?
Arguments
<NR3> specifies the saturation voltage.
Examples
SWLOSS:VSAT might return 4.800000667572E0, indicating that the saturation
voltage is set to 4.80 volts.
TIMe
Sets or queries the oscilloscope time value. The oscilloscope uses the time and
date values to time stamp files saved to the CompactFlash card (TDS2MEM and
TPS2000 Series only), or to the USB flash drive (TDS1000B, TDS2000B, and
TDS2000C Series only), as well as show the time and date on the oscilloscope
display.
Conditions
This command applies to the TDS2MEM, TDS1000B, TDS2000B, TDS2000C,
and TPS2000 Series only.
Group
Miscellaneous
Syntax
TIMe <Q String>
TIMe?
Arguments
<QString> is a time in the form "hh:mm:ss", based on a 24-hour clock (00:00:00
through 23:59:59).
Examples
TIME "1 4:45:00" sets the time to 2 :45 pm.
TDS200, TDS1000/2000, TDS1000B/2000B, TDS2000C, TPS2000 Programmer 2-165