User Manual

Command Descriptions
SWLoss:VALue
:TURNOFF? (Query Only)
Returns the power loss of the device under test when the device is transitioning
between its on and off state. You must enter the saturation voltage of the device
under test us
ing the SWLoss:VSAT command.
This command returns an immediate-measurement value that does not depend of
the current
oscilloscope menu.
Conditions
This command applies to the TPS2000 Se ries with TPS2PWR1 Power Analysis
Module only.
Group
Power Measurement
Syntax
SWLoss:VALue:TURNOFF?
Returns
<NR3>
Examples
SWLOSS:VALUE:TURNOFF? might return
SWLoss:VALue:TURNON? (Query Only)
Returns the power loss of the device under test when the device is transitioning
between its off and on state. You must enter the saturation voltage of the device
under test using the SWLoss:VSAT command.
This command returns an immediate-measurement value that does not depend of
the current oscilloscope menu.
Conditions
This command applies to the TPS2000 Se ries with TPS2PWR1 Power Analysis
Module only.
Group
Power Measurement
Syntax
SWLoss:VALue:TURNON?
Returns
<NR3>
Examples
SWLOSS:VALUE:TURNON? might return
2-164 TDS200, TDS1000/2000, TDS1000B/2000B, TDS2000C, TPS2000 Programmer