User Manual

Command Descriptions
SWLoss:VALue
:CONDUCTION?
Returns the power loss of the device under test when the device is conducting in
its on state. You must enter the saturation voltage of the device under test using
the SWLoss:V
SAT command.
This command returns an immediate-measurement value that does not depend of
the current
oscilloscope menu.
Conditions
This command applies to the TPS2000 Series with TPS2PWR1 Power Analysis
Module only.
Group
Power Measurement
Syntax
SWLoss:VALue:CONDUCTION?
Examples
SWLOSS:VALUE:CONDUCTION? might return 6.0166666667E-2.
SWLoss:VALue:TOTAL? (Query O nly)
Returns the sum of the Turn-On, Turn-Off, and Conduction switching losses.
This command returns an immediate-measurement value that does not depend of
the current oscilloscope menu.
Conditions
This command applies to the TPS2000 Series with TPS2PWR1 Power Analysis
Module only.
Group
Power Measurement
Syntax
SWLoss:VALue:TOTAL?
Returns
<NR3>
Examples
SWLOSS:VALUE:TOTAL? might return
TDS200, TDS1000/2000, TDS1000B/2000B, TDS2000C, TPS2000 Programmer 2-163