User Manual

Command Descriptions
Conditions
This command ap
plies to the TPS2000 Series with TPS2PWR1 Power Analysis
Module only.
Group
Power Measurement
Syntax
SWLoss:TONEND <NR1>
SWLoss:TONEND?
Related Commands
Arguments
<NR1> in percent. Default value is 10.
Examples
SWLOSS:TONEND? might return 10, indicating that Switching Loss Turn-off Start
is set to 10%.
SWLoss:TOFFSTART
Sets or queries a level on the rising e dge of the voltage waveform.
The Turn-Off loss measurement is calculated by integrating the math
waveform between the turn-off start (SWLoss:TOFFSTART) and turn-off end
(SWLoss:TOFFEND) points.
Conditions
This command applies to the TPS2000 Series with TPS2PWR1 Power Analysis
Module only.
Group
Power Measurement
Syntax
SWLoss:TOFFSTART <NR1>
SWLoss:TOFFSTART?
Arguments
<NR1> in percent. Default value is 10.
Examples
SWLOSS:TOFFSTART? might return 10, indicating that Switching Loss Turn-on
End is set to 10%.
SWLoss:TONSTART
Sets or queries a level on the falling edge of the voltage waveform.
TDS200, TDS1000/2000, TDS1000B/2000B, TDS2000C, TPS2000 Programmer 2-161