User Manual

Command Descriptions
Related Commands
SWLoss:ACQuir
e
Arguments
<NR1> defines the number of measurements you want to include.
Examples
SWLOSS:STOPAFTER? might return 15, indicating that the oscilloscope will take
fifteen measurements and stop.
SWLoss:TOFFEND
Sets or queries a level on the first falling edge of the current waveform that occurs
after the turn-off start point (SWLoss:TOFFSTART).
The Turn-Off loss measurement is calculated by integrating the math
waveform between the turn-off start (SWLoss:TOFFSTART) and turn-off end
(SWLoss:TOFFEND) points.
Conditions
This command applies to the TPS2000 Se ries with TPS2PWR1 Power Analysis
Module only.
Group
Power Measurement
Syntax
SWLoss:TOFFEND <NR1>
SWLoss:TOFFEND?
Related Commands
SWLoss:TOFFSTART
Arguments
<NR1> in percent. Default value is 10.
Examples
SWLOSS:TOFFEND? might return 10, indicating that Switching Loss Turn-off
End is set to 10%.
SWLoss:TONEND
Sets or queries a level on the first falling edge of the voltage waveform.
The Turn-On loss measurement is calculated by integrating the math
waveform between the turn-on start (SWLoss:TONSTART) and turn-on e nd
(SWLoss:TONEND) points.
2-160 TDS200, TDS1000/2000, TDS1000B/2000B, TDS2000C, TPS2000 Programmer